Tuesday 27 October 2015

Soaring in the heavens, or descending into Hell: A Valkyrie story.

Greetings,
It's be a good long time since I've posted anything I might say it's because I've been too busy with gaming and other hobby stuff. Or I may say I was occupied with university or work, but they would be poor excuses. The truth is is mainly laziness that has prevented me form posting. But I haven't be completely inactive this whole time. I have managed to work on the flyers for my Rogue Trader themed Imperial Guard force. When I got my airbrush I started looking at different ways to paint with it.  One of the coolest tricks I found was salt chipping. So I soon got an idea to have my Valkyries display a high degree of wear and tear the reasoning being a Rogue Trader on a  lengthy voyage wouldn't be stopping off for a resupply regularly. I would spray my flyers with a bright metallic base, salt that sucker up, paint over the whole lot, and then just chip the salt away to reveal the bare metal of the fuselage.  Easy right?
First I set out for some metallic paint for the airbrush. After some research I discovered that normal metallic paint isn't suitable for airbrushing. Apparently the metallic particles in the pigment tends to
gum up the airbrush. There are products that allow metallic airbrushing like the Model Air range of paints from Vallejo.

What could go wrong?
But me being my usual impatient self just decided to use whatever was available locally in this case cheep silver spay-paint.

So first up I had to assemble the pair of Valkyries I had. I avoided using the instructions for most of the construction. But I had to check them for the location of some of the smaller parts. I stuffed up one of the wing weapon hard-points when I glued it in back to front the only thing that tipped me off was that the angle seemed wrong. Another this was I did was leave the pilots torsos out of the original construction I had to trim them a little to make them fit after they were pained. During the assembly I installed a series of 3mm circular magnets. The idea being that later down the track I could swap out the weapons or even convert them them Vendettas.



Assembly complete. 
Magnets on the hard-points.


Magnets behind the multi-laser.
Top off for future painting.


Magnets for the rear door too.
Rear door magnet works good. 





























Blue painters tape to protect the primer.
The internals a light grey to reflect light. 



Internals painted.
Internals painted. 


Painted flight controls #2
Painted flight controls #1








More blue painters tape.

Blue-tac to protect the cockpit.





What have I done!


Painted pilots  











Canopy fitted over cockpit.
Canopy fitted over cockpit


















Now it's time to start the salt coverage. I grabbed a small bowl of water, some paper towels, a brush, and and some salt. I laid the towel down to help with the mess then used the brush to paint on some small dabs of water I tried to keep the water to the edges of the model but often the surface tension of the droplets broke it was much easier to dab the water on the flat of a panel. Next I sprinkled salt over where I had added the water when the salt  touched the water it congealed otherwise it just fell off. I repeated this process until I thought I had  covered enough of the model. Then I grabbed my airbrush and begun layering up red paint until I couldn't see the base colors anymore. When I was done and the paint had dried I begun the very messy process of brushing all the slat off I used a small house paint brush it fairly soft bristles and the salt came off easily I ended up with a large red salty mess of dried paint. The effect of the chiping actually looked good; I guess because it was actually chipped paint. But the overall look of the miniature looked off. I think I simply used too much salt and in the wrong places.


Ready for the salt

Perhaps too much 





I like the effect but not the placement. Too much in the center of the panels, and too much overall. I think less will be more. 




See! warp is stretched
Forwarriors' fall,
Lo! weft in loom
'Tis wet with blood;
Now fight foreboding,
'Neath friends' swift fingers,
Our grey woof waxeth
With war's alarms,
Our warp bloodred,
Our weft corseblue.
"This woof is y-woven
With entrails of men,
This warp is hardweighted
With heads of the slain,
Spears blood-besprinkled
For spindles we use,
Our loom ironbound,
And arrows our reels;
With swords for our shuttles
This war-woof we work;
So weave we, weird sisters,
Our warwinning woof.